KEITHLEY 2612A LABVIEW DRIVER

Stack Overflow works best with JavaScript enabled. I load a script on keithley a and then I want labview to wait until the instrument has finished running the script. By using our site, you acknowledge that you have read and understand our Cookie Policy , Privacy Policy , and our Terms of Service. You should try to use a delay in your while loop where you continuously read the value of bit 1. Once I compile the program and try to run it on a different computer without LabVIEW, it’s a completely different story. Most Active Hardware Boards: That might just be it!

Uploader: Mojar
Date Added: 4 September 2014
File Size: 17.87 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 70089
Price: Free* [*Free Regsitration Required]

Thank you very much for the tip! Yes, you will need to “write” the control to the instrument using SCPI commands defined in documentation for the instrument. Post as a guest Name. Goes to show how new I am at this I’m downloading the VISA installer right now, and will keitgley an update once it’s installed.

Instrument Control (GPIB, Serial, VISA, IVI)

Update on specific hardware and snapshots of problem will be uploaded as soon as I get them. I downloaded and installed the keithpey that includes NI MAX and ran it, and found that the serial ports don’t even show up. To build a stand-alone program, is there a place in the build options window that I need to specify these sub-vi’s?

  ATI X1200 SERIES DRIVER

WG- I edited the question adding the script and captures from the front panel and block diagram. WG- 1 9 Has anyone else had this problem before, or better yet, have a solution for it? Sign up using Facebook. The following link is an image from the while loop where I continuously read the value of bit 1.

I load a script on keithley a and then I want labview to wait until leithley instrument has finished running the script. Joe Friedrichsen 1, 12 I tried doing it with loop tunnels their values remain constant.

As I mentioned in the opening post, the program properly controls the source meter while running on the original computer, but it cannot find the device when it is compiled and run on a different computer see attached graphic.

Most Ekithley Hardware Boards: You add the knob control, wire the value to the number-to-string VI http: Email Required, but never shown. Message 1 of 5. Sign up or log in Sign up using Google.

By clicking ,eithley Your Answer”, you acknowledge that you have read our updated terms of serviceprivacy policy and cookie policyand that your continued use of the website is subject to these policies. Email Required, but never shown.

  DELL E1405 WIFI DRIVER DOWNLOAD

I thought of trying to set a digio bit and check its value in a while loop.

I don’t have enough reputation points to add images. If you are suspecting a timeout error, why don’t you have a closer look at the error terminal of your keithley vi? Message 4 of 5. Is it possible to put the keitgley button and knob outside the while loop and still get the new value whenever the knob rotates or the button is pressed?

Upload the image somewhere else and provide a link. Post as a guest Name.

Value of Numeric control in script, LabView – Stack Overflow

A loop and a subVI have the same run-time constraints — values on their keitbley terminals cannot change while they are executing. Is it possible to use a Numeric Controller – a Knob for example – and use its value in the script to be loaded to the instrument?

Stack Overflow works best with JavaScript enabled. Message 2 of 5. Did you try debugging your code step by step?