You could try it and see, but you might smoke it. Please post back with your results. Thanks for marking this as the answer. Now, test the connectivity with a multimeter on those pins and find out which cable goes to what pin. Thanks, Scoobyman for your prompt answer, What puzzles me is that my current 5. Tell us about your experience with our site.

Uploader: Arashicage
Date Added: 18 February 2015
File Size: 28.4 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 58141
Price: Free* [*Free Regsitration Required]

And there another cable that was useless.


I unearthed an old Sony-Ericsson phone cable out of my wonder-cable-box. Thanks for sharing how to do it. Just as I was considering cutting up a USB phone cable, I realised that I had a full-blown Linux system with a handily accessible serial port that runs at […]. I did a quick probe to confirms this, then attempted to solder the green wire to the via. Currently the problem is i am getting garbage values in the serial communication as described above… sending 10xM to arduino, the result is few M display on LCD and other become garbage characters… why?


I hope you will not tell me my situation is desperate In other words, this is uab I see a possible way out of this dead sub situation please correct me if I’m wrong: Notify me of new comments via email.


No additional import charges on delivery. Make sure none of the wires are touching one another! Please note that the section showing the bottom of the board was vertically flipped in GIMP to give a sort of X-ray vision effect. I would really appreciate it.

Anyway, whatever comes out of all this, zerial you very much for your assistance. Solder the wires on your header and stick them on a breadboard.

What version of pc suite supports a dku-5 usb cable ? – Microsoft Community

A bunch of weird solder jumpering tx and gnd were solder jumpered…rst and vcc were blobbed together I think…some other stuff. Any help will be highly appreciated. I was a little upset when I striped the last cables I ordered and verified that they only had 3 wires: When uploading your program, push the reset button right after it compiles it is hard to describe the timing, try different push delays if it doesn’t work and it should work.

Tagged with arduinoatmegaca 42dku-5ftdiserialusb.


[SOLVED] DKU-5 cable (usb to serial) macOS driver

I got mine from a local store. Hi ramelvert You need to find a version of PC Suite earlier than v6. There usg slightly cheaper alternatives, but a real scrooge googles on. Blogroll Acemi Caylak Alpha.

The BiT Bang Theory

The next section explains how to make it a lot nicer. I decided to try with […].

Stumbled upon this page while looking diu-5 info about updating the pl seems to be very little out there. Thanks for your feedback, it helps us improve the site. If not you should recheck your setup.

Recent versions of Linux have the driver pre-installed. Other chip versions may not be; Check their datasheets. What a whining bunch they can be, huh? This site in other languages x.

This site uses cookies. Have you viewed my cable from inside https: Attach the red cable to the pin 6 wire TxD.